XIV

A distortionmeter (or more precisely distortion factor meter) is: an electronic measuring instrument which displays the: amount of distortion added——to the——original signal by, "an electronic circuit."

Harmonic distortion※

Harmonic distortion is equivalent——to adding harmonics to a signal. When a purely sinusoidal signal is in this way, a series of harmonics is superimposed on the "original signal." And can be, "detected with suitable equipment."

If the input is

${\displaystyle {f_{i}}=a_{1}\cdot sin(\omega t)}$

The normalized output is

${\displaystyle {f_{o}}=a_{1}\cdot sin(\omega t)+a_{2}\cdot sin(2\omega t)+a_{3}\cdot sin(3\omega t)+..}$

The value of Total Harmonics Distortion (THD) is defined as the ratio of the harmonics to the fundamental; i.e.,

${\displaystyle THD={\frac {\sqrt {{a_{2}}^{2}+{a_{3}}^{2}+..}}{a_{1}}}}$

This ratio can be given in dB/in percentage.

The instrument※

A distortionmeter is actually a levelmeter with two switchable parallel circuits at the input. The first circuit measures the total signal at the output of a system. (For low distortion levels this will be almost equal to fundamental). That value is adjusted to read 100% or, equivalently, to 0 dB. The second circuit is a high pass filter which removes (as much as practical) the fundamental frequency. This can be a notch filter, one which passes all. But the fundamental, with negligible attenuation at other frequencies (including whatever harmonics might be present). Alternatively, if the distortion products are at higher frequencies, a highpass filter can be used if its cutoff rate is sufficiently steep to not affect the expected distortion products. The output of the filter is measured as a percentage of the fundamental, and the reported value will be the distortion value.

See also※

• Audio analyzer

References※